A comparative analysis between homodyne and heterodyne receiver architecture
Manarat International
University Studies 2 ISSN 2414-6773
University Studies 2 ISSN 2414-6773
Abstract
Two available choices for receiver architecture in wireless communications are Homodyne and Heterodyne receivers. Among them, heterodyne receiver was the leading choice in the past compared to homodyne receiver regarding facing challenges in suppressing interference and noise. However, Direct Conversion is becoming popular for wireless communications due to its lower cost. The goal of this paper is to discuss the key problems and tradeoffs in the design of Heterodyne and Homodyne receiver.
References
- Cotter W. Sayre, Complete Wireless Design. McGraw-Hill, 2001.
- Behzad Razavi, RF Microelectronics, Prentice Hall Communication Engineering, 1998.
- B. Razavi, Design Consideration for Direct Conversion Receiver, IEEE Trans. Circuits and Systems-II, Analog and Digital Signal Processing, vol44,no.6,pp428435, June 1997.
- Qizeng Gu, RF System Design of Transceiver for Wireless Communications, Springer Science, 2005.
- Ken Kundert, Accurate and Rapid Measurement of IP2 and IP3,Designer’s guide consulting Inc, 2002
- A. A. Abidi, Direct Conversion Radio Transceiver for Digital Communications, IEEE Journal of Solid State Circuits, Vol.30,pp.1399-1410,December 1995.
- A. Bensky, Short-range Wireless Communication: Fundamentals of RF System Design and Application, 2nd Edition, Amsterdam, -Newnes-Elsevier 2004